AFC Gold Imitation Leaf Flakes

AFC Imitation Leaf Flakes offer a convenient and budget-friendly way to add a touch of metallic elegance to your crafts and artwork. They are a popular choice among artists, hobbyists, and DIY enthusiasts looking to experiment with metallic finishes without the high cost of genuine metal leaf.

To apply imitation leaf flakes to different surfaces, follow these steps for effective results:

Materials Needed
Imitation Leaf Flakes: Available in various colors, such as gold and silver.
Adhesive Size: Choose between water-based or oil-based sizes, depending on your project.
Soft Brush: For applying the adhesive.
Talcum Powder: To prevent the flakes from sticking to your fingers.
Dusting Brush: A soft brush to remove excess flakes.
Burnishing Cloth: A soft cloth or old T-shirt for smoothing the flakes.
Acrylic Sealer: Optional, for protecting the finished surface.

Application Steps
Prepare the Surface: Ensure the surface is clean and dry. If necessary, apply a primer suitable for your surface type (wood, metal, plaster, etc.) to enhance adhesion.
Apply Adhesive Size: Using a soft brush, apply a thin, even layer of adhesive size to the area where you want to place the imitation leaf. The size should be clear and evenly distributed. Allow it to dry until it reaches a tacky state, which typically takes about 15 to 30 minutes. You can check the tackiness by touching it lightly; it should feel sticky but not wet.
Prepare the Imitation Leaf Flakes: Carefully handle the imitation leaf flakes. If they are in sheets, you can cut them into smaller pieces if needed.
Apply the Leaf Flakes: Gently place the flakes onto the tacky adhesive surface. You can use your fingers or a soft brush to press the flakes down lightly. For larger areas, you may want to work with a soft brush to ensure even coverage.
Dust Off Excess Flakes: After applying the flakes, use a soft dusting brush to remove any excess flakes that did not adhere to the adhesive. This helps achieve a clean finish.
Burnish the Surface: Once the flakes are in place, use a soft cloth to gently burnish the surface. This step helps to secure the flakes and gives a smooth appearance.
Seal the Finish: If desired, apply an acrylic sealer to protect the leafed surface, especially if it will be exposed to wear and tear. This is particularly important for surfaces that may be handled frequently.

Surface Compatibility
Imitation leaf flakes can be applied to various surfaces, including:
Paper
Metal
Plaster
Plastic
Wood
Glass

Always ensure that the surface is suitable for the type of adhesive you are using, and follow any specific instructions provided with the imitation leaf product for the best results.

Speedball Adhesive Leaf Pen
Speedball Gold Leaf Adhesive 2oz
Speedball Gold Leaf Sealer 2oz